Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location |
Des... |
Type |
Basic val... |
Toleranc... |
Toleranc... |
| Fastening screws for front part & rear part of heat shield |
M6 x 12 |
Tightening torque |
9 Nm (6.5 ftlb.) |
|
|
| Screws for oil cooler |
M6 x 20 |
Initial tightening |
5 Nm (3.5 ftlb.) |
|
|
| Screws for oil cooler |
M6 x 20 |
Final tightening |
+ 9 Nm (6.5 ftlb.) |
|
|