Preliminary Work
- Electric shock
- Short circuit
- Fire
- Explosion
→ Only appropriately trained and authorized persons may work on high-voltage vehicles and components.
→ Required qualification: High voltage technician or high voltage expert.
→ Observe national requirements and legislation for this work.
→ Always use insulated tools, such as an > VAS 6883 - insulated tool set when working on these parts.
→ Observe general warning notices for working on the high-voltage system.
> 2X00IN GENERAL WARNING NOTICES FOR WORKING ON THE HIGH-VOLTAGE SYSTEM
- Vehicles with particle filter, remove right particle filter:
> 267419 Removing and installing particle filter (V8 biturbo)
> 267419 Removing and installing particle filter (V6 Turbo)
- Vehicles without particle filter, remove right catalytic converter:
> 267319 REMOVING AND INSTALLING CATALYTIC CONVERTER (V8 BITURBO)
> 267319 Removing and installing catalytic converter (V6 Biturbo)
- Only V8 Hybrid:
Remove purge-air duct on bottom half on the right.
> 261219 REMOVE AND INSTALL SHIELD ON CATALYTIC CONVERTER (V8 BITURBO)