Removing Battery Sensor
WARNING: This page is about a different variant/trim than selected.
NOTE:
Voltage peaks
- Risk of damage to electrical load or to the control unit
→ Switch off ignition and keep transmitter key outside of the transmission range (at least 5 m).
→ Switch off electrical loads before disconnecting or removing them.
- Disconnect ground terminal with battery sensor -1-
from the battery.
> 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY
Ground terminal
- Release and disconnect electric plug connection -1-
on the battery sensor.
Electric plug connection
- Unscrew fastening nut -1-
and remove ground line with battery sensor -2-
.
Fastening nut