Installing Brake Booster
WARNING: This page is about a different variant/trim than selected.
Information
Make sure not to damage the push rod boot when installing the brake booster.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Use new seal for brake booster on the body.
- 1.2 Nuts securing brake booster to pedals. >Tightening torque 23 Nm (17 ftlb.) + 2 Nm (1.5 ftlb.)
- 1.3 Union nuts securing brake lines to brake master cylinder. >Tightening torque 18 Nm (13 ftlb.)