Information On Bleeding Routines And Sequences
WARNING: This page is about a different variant/trim than selected.
Information
After replacing or draining brake components, the bleeding routines must be performed in accordance with the table below.
The specified sequence must always be observed.
If several components are affected, the bleeding routine and sequence of the component with the lowest number must be selected.
Information
- Leaks in the brake system can drain the system.
- The bleeding process must then be carried out according to the specifications in Step 1 to ensure that the electric brake booster is also bled.
| Number/Component | Conventional bleeding | Porsche Stability Management (PSM) bleeding routine | Bleeding routine for electric brake booster (eBKV) |
|---|---|---|---|
| 1) Brake booster | 1 | 3 | 2 |
| 2) Brake master cylinder | 1 | 3 | 2 |
| 3) Brake line Brake master cylinder to hydraulic unit |
1 | 2 | - |
| 4) Hydraulic unit | 1 | 2 | - |
| 5) Intake pipe | 1 | 2 | - |
| 6) Brake line Hydraulic unit to brake calliper |
1 | - | - |
| 7) Brake calliper | 1 | - | - |