Removing Engine Cover (Design Cover)

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Components not fitted when engine is running or during test drive

Risk of damage to components due to reduced cooling performance
→ Before starting the engine, make sure that all air-supply components are completely fitted.

→ Only start the engine when the heat shields and design cover are fitted.

→ Only test-drive the vehicle when all underbody panelling, heat shields and the design cover are fitted.

Carefully pull the design cover -1- off the four fastening points one at a time -arrows- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Design cover
Set design cover -1- down with the visible side on a soft surface -2- and check it.
1. 2.1 Check heat insulation, spotwelds and air baffle plates for damage.
  1. 2.1.1 Replace design cover if it is damaged.
2. 2.2 Check rubber elements -3- for damage and replace them if necessary.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Design cover from below