LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (10 Engine - Crankcase, Suspension 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 108319 Removing And Installing Engine Cover (Design Cover) (V6 Turbo) >> Installing Engine Cover (Design Cover)

Installing Engine Cover (Design Cover)

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Components not fitted when engine is running or during test drive 
  • Risk of damage to components due to reduced cooling performance 

    → Before starting the engine, make sure that all air-supply components are completely fitted.

    → Only start the engine when the heat shields and design cover are fitted.

    → Only test-drive the vehicle when all underbody panelling, heat shields and the design cover are fitted.

  1. Install design cover -1-  .
    1. 1.1 Press design cover -1-  evenly onto the fastening points -arrows-  .
      G15821335Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Design cover

  2. Check that the design cover is seated correctly.