Installing Torque Support
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Move torque support -1-
into installation position.
- Fit and -2-
tighten new screws M10 x 70 and M10 x 80.
> Initial tightening 50 Nm (36.9 ftlb.)
> torque angle + 90°
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Torque support - V8 Turbo
- Secure the strut -4-
.
- 3.1 Screw in and tighten screw -5-
.
> Initial tightening 20 Nm (15 ftlb.)
> Final tightening + 90°
 Courtesy of PORSCHE CARS NORTH AMERICA, INC.
|
Screws for strut