LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (10 Engine - Crankcase, Suspension 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 101320 Removing And Installing Oil Spray Jet >> Removing Oil Spray Jet

Removing Oil Spray Jet

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove oil windage tray -1-  .
    G15821301Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Oil windage tray (shown on V6)

    1. 1.1 Unscrew screws -2-  and remove oil windage tray -1-  .

    Information 

    The crankshaft must be turned only in direction of rotation of the engine.

  2. Turn the crankshaft -1-  .
    G15821302Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Crankshaft

    1. 2.1 Turn the crankshaft -1-  using > T40263 - wrench, 21 mm-2-  and > T40314 - adapter-3-  until the connecting rod bolts are accessible.

    Information 

    For re-installation, mark the installation position and allocation of the connecting-rod bearing caps to the cylinder and to the connecting rod.

  3. Remove the relevant connecting-rod bearing caps -1-  .
    G15821303Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Connecting-rod bearing cap

    1. 3.1 Unscrew screw -2-  and remove connecting-rod bearing cap -1-  .
  4. Remove the relevant oil spray jet -1-  .
    G15821304Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Oil spray jet

    1. 4.1 Unscrew screw -2-  .
    2. 4.2 Remove oil spray jet -1-  .
  5. To remove other oil spray jets, repeat the procedure on the relevant oil spray jets.
scientia non olet · About LEMON Manuals