Subsequent Work For Diagnostic Scopes

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Connect tester to the vehicle and start it.
Switch on ignition.
Start diagnostics.
Select engine electronics (DME) control unit.
Select Maintenance/Repairs tab:
1. 5.1 Only for hybrid vehicles: Decoupler commissioning without part replacement
2. 5.2 Only for V6T and V8T: Working on the high-temperature coolant circuit: Draining and filling coolant
3. 5.3 Only for V6T and V8T: Working on the high-temperature coolant circuit: Bleed cooling system
4. 5.4 Only for V6T and V8T: Checking oil level
5. 5.5 Only for reconditioned engine: Performing throttle valve adaptation.
6. 5.6 Only for reconditioned engine: Reset sensor wheel adaptation
  > 287319 REMOVING AND INSTALLING PULSE SENDER
7. 5.7 Only for reconditioned engine V8Tevo: Writing adaptation of camshaft sensors
Select the Drive links/checks tab and reset under Learning values
1. 6.1 Only for replacing injector valves and reconditioned engine: Reset injector valve learning values
2. 6.2 Only for R4: Resetting chain elongation
3. 6.3 Only for R4: Replacing turbocharger and reconditioned engine: Reset, turbocharger learning values
Read out all fault memories , process and delete existing faults if necessary.
Exit the diagnostic application. End operational readiness on the vehicle. Disconnect tester from the vehicle.