Brake Disc Measurement Sheet
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
A copy or print-out of the data card shown here can be used to document the measured result. The data cards cannot be ordered.
- Make a copy or print-out of the data card shown here.
Information
- Actual values that are identical in all versions are already entered!
- Before taking measurements (Test 1 to Test 3), enter the general data, vehicle type and the missing nominal values (new brake disc thickness/brake disc wear limit) in the data card.
- Carry out measurements (actual status) and enter the values in the data card.
- If brake discs are to be replaced, carry out Test 2 with the new discs again and enter the latest values in a new data card.
| Brake disc measurement | ||||
|---|---|---|---|---|
| Customer: | Rep. Order No.: | |||
| Street: | Porsche VIN: | |||
| City: | Reg. number: | |||
| Telephone: | Date of first registration: | |||
| Vehicle type: | Odometer reading [km/miles]: | |||
| Checker: | Date/Signature | |||
| Nominal values | ||||
| Test 1 = Brake disc thickness | ||||
| - Brake disc thickness, new [mm]: | Front: | Rear: | ||
| - Wear limit [mm]: | Front: | Rear: | ||
| Test 2 = Lateral runout | ||||
| - Brake disc installed [mm] | max.: | |||
| - Wheel hub | max.: 0.02 | |||
| - Brake disc removed [mm] | max.: 0.03 | |||
| Test 3 = Thickness tolerance of brake disc | ||||
| Thickness tolerance of brake disc [mm] | max.: | |||
| Measured values (actual values) [mm] | front left front right rear left | rear right | ||
| Test 1 = brake disc thickness (number of measuring points can vary depending on the measuring method) | ||||
| Measurement point 1 | ||||
| Measurement point 2 | ||||
| Measurement point 3 | ||||
| Measurement point 4 | ||||
| Measurement point 5 | ||||
| Measurement point 6 | ||||
| Measurement point 7 | ||||
| Test 2 = Lateral runout | ||||
| - Brake disc installed | ||||
| - Wheel hub | ||||
| - Brake disc removed (difference wheel hub/brake disc installed) | ||||
| Test 3 = Thickness tolerance of brake disc (1) | ||||
| Thickness tolerance (1) | ||||
|
||||