Installing Spreader Device (EPB Actuator)
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Clean the actuator carefully so as not to damage the dust boots.
- Visually inspect the dust boots for cracks.
Information
Do not twist brake shoe mountings during installation.
- Installation is performed in reverse order.
- When re-using the (EPB) actuator, secure it in the brake shoe mountings with a tie-wrap to prevent it from twisting -arrow-
.
Securing actuator for EPB
- Screw in and tighten new
screws
> Initial tightening 20 Nm (15 ftlb.)
> Final tightening + 60°