LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 4 (46 Brakes - Brake Mechanism 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 465319 Removing And Installing Rear Brake Disc >> Removing Rear Brake Disc

Removing Rear Brake Disc

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Removal of brake calliper 
  • Paint defects on brake calliper 

    → Proceed with care when setting back the brake pads.

    → Protect the paintwork on the brake calliper from damage using a suitable cloth.

  1. Select brake pad change mode using > 9900 - PIWIS Tester 3  .
    1. 1.1 Select → 'Brake electronics (PSM, incl. parking brake)'  in the 'Control unit overview'  and press F12 confirm your selection.
    2. 1.2 Select 'Drive links/checks'  → 'Start brake pad change mode'  and start the procedure.
  2. Release and disconnect electric plug connection for brake pad wear indicator -1-  .
    G15856940Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Electric plug connection for brake pad wear indicator

    Information 

    Do not open the brake hydraulic system.

    Information 

    • Do not use an impact bolter. 
  3. Unscrew screws -arrows-  and loosen the brake calliper from the wheel bearing housing.
    G15856941Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Loosening brake calliper

  4. Hang the brake calliper at a suitable position in the wheel housing.
  5. Unscrew screws -arrows-  and remove brake disc.
    G15856942Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing brake disc

scientia non olet · About LEMON Manuals