Subsequent Work

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Position electric wire harness for starter -2- on the bolt and screw in and tighten nut -1- > Tightening torque 20 Nm (15 ftlb.)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric wire harness for starter
Fit protection cap -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Protection cap
Install rear cardan shaft.
> 393519 REMOVING AND INSTALLING REAR CARDAN SHAFT
Install ATF cooling line (rear section).
> WM, 386219 REMOVING AND INSTALLING ATF COOLING LINE (REAR SECTION)
Install power-steering gear.
> 489055 REPLACING POWER-STEERING GEAR
Remove catalytic converter(s).
V6 biturbo:

> Removing and installing catalytic converter (V6 BT)

V6 monoturbo:

> WM, 267319 REMOVING AND INSTALLING CATALYTIC CONVERTER (V6 MONOTURBO)
Install front-axle support (front section).
> WM, 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT
Install primary catalytic converter(s).
V6 biturbo:

> Removing and installing primary catalytic converter (V6 biturbo)

V6 monoturbo:

> WM, 267619 REMOVING AND INSTALLING PRIMARY CATALYTIC CONVERTER (V6 MONOTURBO)
Connect the battery.
> WM, 2X00IN WORK INSTRUCTIONS AFTER DISCONNECTING THE BATTERY