LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (40 Wheel Suspension Front Drive Shaft 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 407919 Removing And Installing Anti-Roll Bar Mount >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Only for e-Hybrid vehicles:  Observe warning notes.

    > Refer to the appropriate Service Information for General warning notes for working on the high-voltage electrical system

  2. Only for e-Hybrid vehicles:  Isolate the high-voltage system from the power supply and complete the relevant documentation.

    > Refer to the appropriate Service Information for Isolating high-voltage electrical system from power supply/Starting high-voltage electrical system (AFES)

  3. Remove front anti-roll bar.

    > WM, 407719 REMOVING AND INSTALLING FRONT ANTI-ROLL BAR 

  4. Remove rear part of front wheel housing liner on both sides of the vehicle.

    > WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER