Subsequent Work

WARNING: This page is about a different car, the 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Install front speed sensor.
> 451155 REPLACING FRONT SPEED SENSOR
Install connecting link for anti-roll bar.
> 407819 REMOVING AND INSTALLING CONNECTING LINK FOR ANTI-ROLL BAR
Install brake disc.
> 465019 REMOVING AND INSTALLING FRONT BRAKE DISC

> 465119 REMOVING AND INSTALLING FRONT PCCB BRAKE DISC
Tighten axle nut -1- . Operate the brake while doing this (2nd mechanic required).
On vehicles with all-wheel drive: > Tightening torque 460 Nm (340 ftlb.)

On vehicles without all-wheel drive: > Initial tightening 200 Nm (148 ftlb.) > Final tightening + 100°

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Axle nut (front axle shown)
If the wheel bearing housing was replaced: Perform suspension alignment.
> WM, 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT