LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (40 Wheel Suspension Front Drive Shaft 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 400619 Removing And Reinstalling Front-Axle Carrier >> Subsequent Work

Subsequent Work

WARNING: This page is about a different car, the 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove engine safety device.

    > 1001IN SUPPORTING ENGINE ON THE BODY (ENGINE SAFETY DEVICE)

  2. Only for vehicles with all-wheel drive:  Install spring struts with drive shafts

    > 408519 REMOVING AND INSTALLING FRONT SPRING STRUT 

    > 433019 REMOVING AND INSTALLING FRONT AIR-SPRING STRUT

  3. Install front-axle support.

    > WM, 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT 

  4. Install wheel housing liner on both sides of the vehicle.

    > WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER

  5. Install front wheels.

    > WM, 440519 REMOVING AND FITTING WHEEL

  6. Only for vehicles with PDCC:  Start the 48 V vehicle electrical system.

    > WM, 270703 DISCONNECTING AND STARTING 48 V SYSTEM

  7. Fill up the ATF.

    > WM, 370235 CHECKING AND TOPPING UP ATF

  8. Perform suspension alignment.

    > 449503 PERFORMING FRONT AND REAR SUSPENSION ALIGNMENT

scientia non olet · About LEMON Manuals