LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 24 (40 Wheel Suspension Front Drive Shaft 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 400619 Removing And Reinstalling Front-Axle Carrier >> Preliminary Work

Preliminary Work

WARNING: This page is about a different car, the 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Only for vehicles with PDCC:  Disconnect 48-volt vehicle electrical system.

    > WM, 270703 DISCONNECTING AND STARTING 48 V SYSTEM

  2. Remove front wheels.

    > WM, 440519 REMOVING AND FITTING WHEEL

  3. Remove wheel housing liner on both sides of the vehicle.

    > WM, 505619 REMOVING AND INSTALLING FRONT WHEEL HOUSING LINER

  4. Remove front-axle support.

    > WM, 400819 REMOVING AND INSTALLING FRONT-AXLE SUPPORT 

  5. Only for vehicles with all-wheel drive:  Remove spring struts with drive shafts

    > 408519 REMOVING AND INSTALLING FRONT SPRING STRUT 

    > 433019 REMOVING AND INSTALLING FRONT AIR-SPRING STRUT

  6. Support the engine on the body.

    > 1001IN SUPPORTING ENGINE ON THE BODY (ENGINE SAFETY DEVICE)

scientia non olet · About LEMON Manuals