Pressure Pipe And Intake Pipe (V6 Monoturbo)

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Pressure Pipe And Intake Pipe Components Location With Torque Specification (Monoturbo)

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pressure pipe and intake pipe (monoturbo)

1	Intake pipe
2	Pressure pipe
3	Seal/replace if damaged
4	Screws, M6 x 32 > Tightening torque 9 Nm (6.5 ftlb.)
5	Centre intake-air distributor

Charge air cooler

Fig 2: Charge-Air Cooler Components Location With Torque Specification - V6 Monoturbo

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Charge-air cooler - V6 monoturbo

1	Charge-air cooler
2	Pressure hose, left
3	Pressure hose, right
4	Screw-type clamp > Tightening torque 5.5 Nm (4 ftlb.) +/- 0.5 Nm (0.4 ftlb.)
not pictured	Screw > Tightening torque 5 Nm (3.5 ftlb.)