Installing Pressure Sensor
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Installation is performed in reverse order. Pay particular attention to the following:
- 1.1 Replace O-ring on pressure sensor.
- 1.2 Tighten screw on pressure sensor (for Centre intake-air distributor) to > Tightening torque 5 Nm (3.5 ftlb.)
- 1.3 Tighten screw on pressure sensor (for charge-air cooler) to > Tightening torque 5 Nm (3.5 ftlb.) .