LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 18 (20 Fuel Supply, Actuator 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 207019 Removing And Installing Control Unit For Fuel Pump >> Removing Control Unit For Fuel Pump

Removing Control Unit For Fuel Pump

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Voltage peaks 
  • Risk of damage to electrical load or to the control unit 

    → Remove the ignition key and switch off load before disconnecting or removing load.

  1. Release and disconnect electric plug connection -2-  on control unit for fuel pump -1-  .
    G15876774Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Releasing and pulling off electric plug connection

  2. Unclip line bracket -3-  .
    G15876775Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unclipping line bracket

  3. Unscrew nut -4-  and remove holder with control unit for fuel pump -1-  .
    G15876776Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Removing control unit for fuel pump

  4. Unclip control unit for fuel pump -1-  from holder -5-  (-arrows-  ).
    G15876777Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Unclipping control unit for fuel pump