Installing Balance Shaft Bearing

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Fit adapter T40395/2 on the roller bearing at the correct side. The chamfer -Arrow- must be facing the roller bearing and determines the installation depth.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adapter T40395/2
Align adapter -T40395/3- . The side without the chamfer -Arrows- points downwards

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Adapter T40395/3
Insert roller bearing at the front -1- and rear -2- using the spindle -T40395/1- , adapter - T40395/2- and adapter -T40395/3- as far as it will go by turning the nut -T40395/4- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Using special tool T40395