Installing Belt TENSIONER (Generator)
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
Information
Loosen belt tensioner slowly and in a controlled manner because otherwise oil can leak out via the bellows.
Information
- Replace screws.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten screw securing belt tensioner (generator) to crankcase (Panamera 4S) .
> Initial tightening 8 Nm (6 ftlb.)
> Final tightening + 45°
Screw in and tighten screw securing belt tensioner (generator) to crankcase (Panamera Turbo) .
> Tightening torque 32 Nm (24 ftlb.)
> Tightening torque 32 Nm (24 ftlb.)