Removing Flywheel

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Dirt and contamination

Risk of damage to units or components
→ Protect components from dirt and contamination.

→ Clean or replace dirty components.

Component overview:

Fig 1: Flywheel, Hall-Sender Rotor And Sealing Ring Components Location

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Component overview of flywheel, hall-sender rotor and sealing ring

1	Screw for flywheel, M10 x 29 (multiple-tooth screw, a/f 12, micro-self-locking) - Replace screws!
2	Flywheel
3	Hall-sender rotor
4	Sealing ring for crankshaft on transmission side
5	Centring pin

Position special tool > 10-201 - holder-1- with two washers -2- as shown on the flywheel -arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Counter at the flywheel when loosening
Loosen and unscrew screws on the flywheel.
1. 2.1 Screws are micro-self-locking and must be replaced!
2. 2.2 Remove flywheel and hall-sender rotor.