Installing Sealing Ring

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Dirt and contamination

Risk of damage to units or components
→ Protect components from dirt and contamination.

→ Clean or replace dirty components.

Tools: > T10122 - Insertion tool for sealing ring

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tools for fitting sealing ring

1	Sleeve T10122/1
2	Mounting T10122/2
3	Pressure piece T10122/3

Slide new sealing ring -1- with the closed side -2- over the sleeve -3- onto the mounting -4- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Sliding sealing ring onto mounting
Fit mounting -1- with new sealing ring -2- on the crankshaft flange -arrow- . Check position of centring pin -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting on crankshaft flange
Tap in sealing ring with the pressure piece -1- as far as it will go using a plastic hammer -arrow- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Tapping in sealing ring with pressure piece