Technical Values
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Des... | Type | Basic val... | Toleranc... | Toleranc... |
|---|---|---|---|---|---|
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 18 (3 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing oil windage tray to crankcase | M6 x 30 (13 ea.)/replace, tighten crosswise | Final tightening | + 90° | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Initial tightening | 3 Nm (2 ftlb.) | ||
| Screw securing chain housing cover to oil windage tray | M6 x 25 (2 ea.)/replace, observe tightening sequence | Final tightening | + 90° | ||
| screws for crankshaft bearing covers | Replace following removal. | Initial tightening | 30 Nm (22.1 ftlb.) | ||
| Screws for crankshaft bearing covers | Replace following removal. | Torque angle | + 90° | ||
| Screws for crankshaft bearing covers, side | Replace following removal. | Tightening torque | 20 Nm (14.8 ftlb.) | ||
| Screws for crankshaft bearing covers, side | Replace following removal. | Torque angle | + 90° |