Subsequent Work

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Install crankshaft.
> Removing and installing crankshaft (V6 Turbo)
Install oil windage tray -2- .
1. 2.1 Position oil windage tray -2- on cylinder block.
2. 2.2 Replace screws for oil windage tray -1 and 3- .
3. 2.3 Fit screws securing oil windage tray to cylinder block -1- and tighten crosswise.
  Tighten M6 x 18 screws (3 ea.) to > Initial tightening 3 Nm (2 ftlb.) and > Final tightening + 90° .
  
  Tighten M6 x 30 screws (13 ea.) to > Initial tightening 3 Nm (2 ftlb.) and > Final tightening + 90° .
4. 2.4 Tighten screws securing chain housing cover to oil windage tray -3- to > Initial tightening 3 Nm (2 ftlb.) and > Final tightening + 90° .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil plate
Install oil guide housing.
> Removing and installing oil guide housing (V6 Turbo)