Removing Cylinder Head Cover (Left Cylinder Bank)

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

The steps described here are shown on the right cylinder bank, but also apply for the opposite side.

Remove stoppers on camshafts -1- .
1. 1.1 Unscrew screw on stopper -2- .
2. 1.2 Remove stoppers on camshafts -1- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Stoppers on camshafts
Release and disconnect electric plug connections for camshaft sensors -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connections for camshaft sensors
Remove cylinder head cover -20- .
1. 3.1 Unscrew screws on cylinder head cover -1 to 19- .
2. 3.2 Depending on type:
  Screw two screws (M8 x 25) into the threaded bores -Arrows- by hand.
  1. 3.2.1 Tighten screws alternately by half a turn until the cylinder head cover -20- is loosened.
3. 3.3 Loosen cylinder head cover using a plastic wedge.
4. 3.4 Remove cylinder head cover -20- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing cylinder head cover for left cylinder bank