Technical Values
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screw securing additional coolant pump flange to cylinder head | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Screw on guide tube for oil dipstick | Replace O-ring. | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Screws on coolant control valve | Tightening torque | 9 Nm (6.5 ftlb.) | |||
| Vent line for cylinder head | Tightening torque | 9 Nm (6.6 ftlb.) | |||
| Screw for front coolant pipe on right cylinder head | Tightening torque | 9 Nm (6.6 ftlb.) | |||
| Screw for side coolant pipe on right cylinder head | Tightening torque | 9 Nm (6.6 ftlb.) | |||
| Screws for coolant pipe on left cylinder bank | Tightening torque | 9 Nm (6.6 ftlb.) | |||
| Screw for right cylinder head | Replace following removal. | Initial tightening | 30 Nm (22 ftlb.) | ||
| Screw for right cylinder head | Replace following removal. | Tightening torque | 50 Nm (37 ftlb.) | ||
| Screw for right cylinder head | Replace following removal. | Torque angle | + 90° | ||
| Screw for right cylinder head | Replace following removal. | Final tightening | + 90° | ||
| Screw for right cylinder head | Replace following removal. | Initial tightening | 10 Nm (7.5 ftlb.) | ||
| Screw for right cylinder head | Replace following removal. | Torque angle | + 90° | ||
| Screw for right cylinder head | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screw for right cylinder head | Replace following removal. | Torque angle | + 90° | ||
| Screw for left cylinder head | Replace following removal. | Initial tightening | 30 Nm (22 ftlb.) | ||
| Screw for left cylinder head | Replace following removal. | Tightening torque | 50 Nm (37 ftlb.) | ||
| Screw for left cylinder head | Replace following removal. | Torque angle | + 90° | ||
| Screw for left cylinder head | Replace following removal. | Final tightening | + 90° | ||
| Screw for left cylinder head | Replace following removal. | Initial tightening | 10 Nm (7.5 ftlb.) | ||
| Screw for left cylinder head | Replace following removal. | Initial tightening | 8 Nm (6 ftlb.) | ||
| Screw for left cylinder head | Replace following removal. | Torque angle | + 90° | ||
| Fastening screw for turbocharger lines | M6 | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Maximum permissible distortion on cylinder head | Control value | 0.1 mm | |||
| Minimum dimension on cylinder head | Control value | 138 mm | +/- 0.1 mm |