LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (15 Engine - Cylinder Head, Valve Drive 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 155519 Removing And Installing Solenoid Hydraulic Valve For Valve Lift Adjustment (V6 Turbo) >> Installing Solenoid Hydraulic Valve For Valve Lift Adjustment

Installing Solenoid Hydraulic Valve For Valve Lift Adjustment

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installation is performed in reverse order. Pay particular attention to the following:
    1. 1.1 Replace O-ring on solenoid hydraulic valve for valve lift adjustment.
    2. 1.2 Tighten screws for solenoid hydraulic valve for valve lift adjustment to > Initial tightening 3 Nm (2 ftlb.)  and > Torque angle + 90°  .
scientia non olet · About LEMON Manuals