Installing Camshaft Controller Actuator

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Dirt and contamination

Risk of damage to units or components
→ Protect components from dirt and contamination.

→ Clean or replace dirty components.

Installation is performed in reverse order. Pay particular attention to the following:
Replace sealing ring on camshaft controller actuator.

Screw for camshaft controller actuator > Tightening torque 9 Nm (6.5 ftlb.)

Nut for coolant pipe holder, top: > Tightening torque 9 Nm (6.6 ftlb.)

Screw for coolant pipe holder, bottom: > Tightening torque 8 Nm (6 ftlb.)