Subsequent Work

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Only for installing upper chain housing cover on right cylinder bank:

Fit additional coolant pump holder.
1. 1.1 Position additional coolant pump holder -1- , fit double screw securing holder to chain housing cover -3- and tighten to > Tightening torque 9 Nm (6.6 ftlb.) .
2. 1.2 Fit screws securing additional coolant pump to holder -2- and tighten to > Tightening torque 1.5 Nm (1.1 ftlb.) .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Additional coolant pump (right cylinder bank)
Install engine.
> Removing and installing engine