Subsequent Work
WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
- Remove all staking tools.
- Fit stoppers on camshafts -1-
.
- 2.1 Insert stoppers on camshafts -1- .
- 2.2 Fit screws for stoppers -1- and tighten to > Tightening torque 9 Nm (6.5 ftlb.) .
Stoppers on camshafts.
- Fit screw plug in bore for crankshaft locking pin and tighten it.
Old variant with O-ring - replace O-ring : > Tightening torque 25 Nm (18.4 ftlb.)
New variant with micro-encapsulation - Use new screw plug : > Tightening torque 40 Nm (29.5 ftlb.)
- Only for V6 monoturbo:
Install intake distributor centre.
> Removing and installing centre intake-air distributor (V6 monoturbo)
- Install brake booster vacuum pump.
- Install upper chain housing cover.
> WM, 153319 REMOVING AND INSTALLING UPPER CHAIN HOUSING COVER (V6 TURBO)