Removing Rear Panoramic Roof Glass Panel
Information
The rear panoramic roof glass panel cannot be removed without damaging it.
Information
- The procedure for removing car windows is described in
Information
Cut carefully. Do not damage the paintwork or windscreen.
- Open the rear lid.
- Unscrew nuts -2-
.
Nuts
- Unscrew threaded bolt -1-
.
Threaded bolt
- Cut off the foam surround -1-
around the rear panoramic roof glass panel using a cutter.
Foam surround
- Mask the roof pillar and rear lid with adhesive tape -1-
.
Masking
WARNING: Vehicle windows removed and installed incorrectly- Danger of cuts
- Risk of eye injuries
→ Wear personal protective gear.
→ Always shut off power supply when replacing cutting knife.
- Pierce adhesive bead on the left roof edge using a scratch awl -1-
and guide cutting cord into the passenger compartment.
Cutting cord
- Cut adhesive bead at the rear using > VAS 861 001A - Window removal set
.
Adhesive bead at the rear
- Cut adhesive bead on both sides using > VAS 861 001A - Window removal set
> Adhesive bead at the sides
Adhesive bead at the sides
- Cut adhesive bead at the front.
Adhesive bead at the front
- 9.1 Pierce adhesive bead on the front roof assembly at the right using a scratch awl -1- and guide cutting cord into the interior of the vehicle.
- 9.2 Cut adhesive bead at the front using > VAS 861 001A - Window removal set > Adhesive bead at the sides
- Cut adhesive bead at the front corner on both sides using > VAS 861 001A - Window removal set
.
Adhesive bead at front corner
Information
The help of another person is required.
- Remove rear panoramic roof glass panel with the help of another person.