Installing Rear Logo

Information 

• Carefully clean any dirt, grease, wax and other impurities off the fitting area of the body using isopropyl  .
• Always use a clean cloth  .
• The room and object temperature must be at least  > Nominal value + 15°C  .
• Air humidity must be  > Nominal value 50 % +/- 10 %  .
• Do not touch the bonding surface again after removing the protective paper  .
• Wear clean gloves during the bonding process in order to guarantee adequate adhesion  .
• The parts must have been bonded for at least  > Nominal value 72 h before washing the vehicle in a car wash  .

Information 

To ensure that the logo template does not lose its shape, always store the logo template on the relevant support (packaging) after using it.