Removing 48-Volt Power Distributor

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Installation position of 48-volt power distributor

1. Unscrew and remove the fastening screw -1-  for the support -2-  for the centre luggage compartment floor at the right.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Loosening support for centre boot floor plate (at the right in direction of travel)

2. Unclip the support -2-  for the centre luggage compartment floor at the front in direction of travel -A-  and lift it up.
3. Lift up cover for 48-volt power distributor -arrow-  and open the cover.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Opening cover on power distributor

4. Unscrew and remove the fastening screw -1-  for the 48-volt power distributor.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Removing power distributor

5. Mark the electric lines in the correct installation sequence (e.g. with adhesive tape - 1, 2, 3, 4).
6. Unscrew and remove the fastening nuts -2, 3, 4, 5-  for the electric lines.
7. Remove the marked electric lines from the power distributor.