Installing 48-Volt Power Distributor
- Fit the marked electric lines in the correct installation sequence on the screw bolts on the 48-volt power distributor.
- Secure the electric lines -2, 3, 4, 5-
with new fastening nuts > Tightening torque 5 Nm (3.5 ftlb.)
Installing 48-volt power distributor
- Position the 48-volt power distributor in the boot floor plate and secure with the fastening screw -1- > Tightening torque 5 Nm (3.5 ftlb.)
- Close the cover on the 48-volt power distributor until the lid engages securely.
Closing cover on power distributor
- Clip in the support -2-
for the centre luggage compartment floor at the right in direction of travel -A-
.
Installing support for centre boot floor plate
- Secure the support -2- for the centre luggage compartment floor at the right using the fastening screw -1- .