Installing Optical WAVEGUIDE (Central Computer To TV Tuner To Surround View Camera Control Unit)

Information 

Read general information on optical waveguides.

> General information on optical waveguides - MOST bus 

Information 

• New electric lines are secured at the mounting points for the old electric lines. 
• The damaged electric wire harness remains installed in the vehicle. 
• The damaged electric wire harness is only disconnected directly at connected components. 

  Information 

  • Do not damage the insulation on the optical waveguides during installation. 

  Information 

  The range of spare parts available for optical waveguides depends on equipment. There is a specific set containing the individual optical waveguides to suit the equipment in the vehicle.

  Select the required optical waveguide and remove it from the set.

1. Insulate damaged optical waveguide and tie it to the main wire harness.
2. Secure new optical waveguide to main wire harness.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Cable duct

   1. 2.1 Release locking lugs -arrows-  and open cable duct -1-  .
   2. 2.2 Secure new optical waveguide to main wire harness.
   3. 2.3 Close cable duct -1-  .
3. Secure new optical waveguide to main wire harness.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Cable duct

   1. 3.1 Release locking lugs -arrows-  and open cable duct -1-  .
   2. 3.2 Secure new optical waveguide to main wire harness.
   3. 3.3 Close cable duct -1-  .
4. Tie new optical waveguide to main wire harness.

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Cable duct

   1. 4.1 Release locking lugs -arrows-  and open cable duct -1-  .
   2. 4.2 Secure new optical waveguide to main wire harness.
   3. 4.3 Close cable duct -1-  .