Installing Wire Harness For Engine
- Risk of damage to lines and hoses
- Malfunction and fault memory entry on control unit
→ Avoid small bending radii when routing lines.
→ File down edges and burrs in the routing area or mask them with adhesive tape.
→ Maintain a sufficient distance from components exposed to high temperatures while driving.
Information
See information on installing the wire harness.
- When installing the wire harness, make sure that the individual wiring harnesses do not become twisted or entangled.
- The wire harness must be installed back in its original routing.
- If cable retainers, anti-chafing elements or guides were removed during removal, these must be re-attached at their original positions during installation.
- Replace damaged clips.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten screw securing ground lines to valve cover > Tightening torque 6.9 Nm (5 ftlb.)
- Risk of damage to lines and hoses
- Malfunction and fault memory entry on control unit
→ Avoid small bending radii when routing lines.
→ File down edges and burrs in the routing area or mask them with adhesive tape.
→ Maintain a sufficient distance from components exposed to high temperatures while driving.
Information
See information on installing the wire harness.
- When installing the wire harness, make sure that the individual wiring harnesses do not become twisted or entangled.
- The wire harness must be installed back in its original routing.
- If cable retainers, anti-chafing elements or guides were removed during removal, these must be re-attached at their original positions during installation.
- Replace damaged clip connections.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw ground line screws into cylinder head and tighten > Tightening torque 6.9 Nm (5 ftlb.)