Technical Values
WARNING: This page is about a different variant/trim than selected.
| Location | Description | Type | Basic value | Tolerance 1 | Tolerance 2 |
|---|---|---|---|---|---|
| Screw for fuel collection pipe | M6 x 16/observe tightening sequence | Initial tightening | 7 Nm (5 ftlb.) | ||
| Screw for fuel collection pipe | Final tightening | 10 Nm (7.5 ftlb.) | |||
| Screw for clamp on high-pressure line | M6 x 12 | Tightening torque | 9 Nm (6.5 ftlb.) | ||
| Union nut for fuel high-pressure line | Coat thread on union nuts with Microgleit DF 977S. Leave to dry off for at least 5 minutes before fitting. Observe specified tightening sequence! | Initial tightening | 8 Nm (6 ftlb.) | ||
| Union nut for fuel high-pressure line | Final tightening | + 50° |