Removing Oil Guide Housing

WARNING: This page is about a different variant/trim than selected.

WARNING: Toxic substances

Danger of poisoning or suffocation
Danger of burns to the eyes and skin
→ Ventilate the work area well.

→ Never ingest or inhale.

→ Read specific information on the Hazard Sheet.

→ Wear personal protective gear.

→ Do not smoke, eat or drink in the work area.

WARNING: Hot fluid

Danger of scalding
→ Let the fluid cool down.

→ Wear personal protective gear.

WARNING: Highly inflammable or explosive materials

Danger of fire or explosion
→ Avoid contact with hot parts or sources of ignition.

→ Use suction to remove ignitable vapors.

→ Attach warning sign in a clearly visible position.

→ Contain leaked media using non-flammable absorbent material and put it in a container designed for this purpose for disposal in accordance with local requirements.

→ Secure collection containers/vessels to prevent them from tipping over.

Remove shaft cover -1- on both sides of the engine.
1. 1.1 Unscrew screws -2- .
2. 1.2 Remove shaft cover -1- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Shaft cover
Remove pipe for drive shaft -1- .
1. 2.1 Remove O-ring -2- on both sides of the engine.
2. 2.2 Press pipe for drive shaft -1- through from one side using a suitable tool and guide it out on the opposite side.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Pipe for drive shaft
Remove oil intake tube -1- .
1. 3.1 Unscrew and remove screw -2- .
2. 3.2 Pull oil intake tube -1- off the oil pump.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil intake tube
Expose electric wire harness -2- (-arrows- ).
1. 4.1 Release and disconnect electric plug connection -1- .
2. 4.2 Expose electric wire harness -2- (-arrows- ) and set it aside.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric wire harness for oil guide housing
Unscrew screws -21 to 20- in descending sequence.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Screws behind flywheel
Unscrew screws -19 to 1- in descending sequence.

Fig 1: Oil Guide Housing Screws Loosening Sequence
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil guide housing screws

Information

To prevent dirt from getting into the lubrication system, open parts of the engine must be covered.
Remove oil guide housing -1- .
1. 7.1 Screw in screws -2- as far as they will go.
2. 7.2 Screw in screws -2- crosswise by half a turn until the oil guide housing -1- is released.
3. 7.3 Unscrew screws -2- and remove oil guide housing -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Oil guide housing