Installing Final Drive

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

Information

Always use an intermediate layer (e.g. hard rubber) when using the jack!

Fit final drive -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Final drive mounting
1. 1.1 Position final drive in installation position using > VAS 6931 - engine and gearbox jack .
2. 1.2 Tighten fastening screws -3- > Initial tightening 60 Nm (44.3 ftlb.) > Final tightening torque angle + 90°
  Information
  - The bolts -2- can be used several times as part of this repair work.
3. 1.3 Tighten fastening screws -2- > Initial tightening 60 Nm (44.3 ftlb.) > Final tightening torque angle + 90°
Only for vehicles with rear-differential lock: Connect and lock electric plug connection -2- on servo motor for rear-differential lock -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Electric plug connection on servo motor for rear-differential lock
Only for vehicles with rear axle steering: Install support -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for support
1. 3.1 Tighten fastening screws -2- > Initial tightening 70 Nm (51.6 ftlb.) > Final tightening torque angle + 90°
Install protective plate for left drive shaft -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Mounting for protective plate for left drive shaft
1. 4.1 Tighten fastening screws -2- > Tightening torque 8 Nm (5.9 ftlb.)