Installing Antenna Line (Connection Point In Roof To TV Tuner)
NOTE:
Voltage peaks
- Risk of damage to electrical load or to the control unit
→ Remove the ignition key and switch off load before disconnecting or removing load.
Information
- New electric lines are secured at the mounting points for the old electric lines.
- The old electric wire harness remains installed in the vehicle.
- The old electric wire harness is only disconnected directly at connected components.
Information
- Make sure not to damage the insulation when installing the electric wire harness.
- Disconnect antenna line at the connection point in the roof.
- Cut off electric plug connections on the damaged antenna line, insulate it and secure it to the main wire harness.
- Route the new antenna line along the main wire harness, guide it through the existing cable ducts and secure it to the main wire harness using tie-wraps.
- Route new antenna line at the connection point in the roof and secure it.