Installing Heat Shield For Turbocharger

WARNING: This page is about a different variant/trim than selected.

Install heat shield for turbocharger -3- .

1.1 Move heat shield -3- into installation position.
1.2 Fit and tighten nuts -1 and 2- .
Nuts on heat shield, front -1- : > Tightening torque 5 Nm (3.7 ftlb.)

Nuts on heat shield, rear -2- : > Tightening torque 9 Nm (6.6 ftlb.)

1.3 Clip lines for the oxygen sensors -4 and 5- into the clips -6- on the heat shield.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Heat shield on turbocharger