Removing Fuel Line (High-Pressure, Right)

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Hot fuel and hot fuel lines.

Danger of scalding
→ Allow the fuel to cool down before opening line connections.

→ Wear protective gloves.

→ Wear protective goggles.

Information

The rules relating to cleanliness and instructions for working on the fuel system must always be observed before and during the work.

> WM, 2X00IN RULES RELATING TO CLEANLINESS AND INSTRUCTIONS FOR WORKING ON THE FUEL SYSTEM

> WM, 2X00IN BASIC SAFETY INSTRUCTIONS FOR WORKING WITH THE FUEL SYSTEM

Information

Check fuel line for damage following removal and replace it if necessary.

Expose fuel line.
1. 1.1 Release and disconnect electric plug connection -4- for ignition coils -1- .
2. 1.2 Loosen oxygen sensor lines -2- from cable duct -3- .
3. 1.3 Pull cable duct -3- off ball studs -arrows- and set it aside.
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Overview of cylinder bank 1
Remove fuel line -1- .
1. 2.1 Press sound absorber aside and unscrew union nut -2- on the rail.
2. 2.2 Unscrew union nuts -3- .
  Information
  - Open connections and lines must be closed off using suitable stoppers or caps.
3. 2.3 Unscrew screw -4- and guide out fuel line with holder -1- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing fuel line