Removing All-Wheel Final Drive

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.

WARNING: Danger of objects or loads falling down

Risk of squashing or crushing
→ Secure components to prevent them from falling down.

Fit impact puller.
1. 1.1 > 9799 - Impact puller must be fitted at the groove in the connecting shaft using four screws -1- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Fitting tool (similar to illustration)
Loosen connecting shaft.
1. 2.1 Use > 9799 - impact puller to remove connecting shaft from all-wheel final drive -arrow- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Removing and fitting connecting shaft (similar to illustration)
Remove console.
1. 3.1 Unscrew fastening screws -1- and remove console -2- .
2. 3.2 Remove circlip -3- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Final drive console
Remove coolant lines -1- .
1. 4.1 Unclip positive cable at three places.
2. 4.2 Unscrew screws -2 and 3- and nut -4- .
3. 4.3 Loosen clamps -5- .
4. 4.4 Remove coolant lines -1- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Coolant lines
Remove right engine mount -2- .
1. 5.1 Unscrew screws -1- and remove engine mount -2- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Right engine mount
Remove right engine carrier -2- .
1. 6.1 Unscrew screws -1- and remove engine carrier -2- .
Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Right engine carrier
Remove all-wheel final drive.
1. 7.1 Unscrew screws -4- and remove all-wheel final drive -3- .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Front-axle final drive