LEMON Manuals: Even more car manuals for everyone
Home >> Porsche >> 2021 >> Panamera 4 >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (26 Exhaust System 3.0L Turbo -- 971 - PANAMERA (971)) >> WM, 260119 Removing And Installing Exhaust System >> Installing Exhaust System

Installing Exhaust System

WARNING: This page is about a different car, the 2020 Porsche Panamera, 2019 Porsche Panamera, 2018 Porsche Panamera, and 2017 Porsche Panamera. However, it is still accessible from the selected car via links, so may be relevant.
  1. Installing exhaust system
    1. 1.1 Position exhaust system on a transmission jack and secure it with a tension strap -arrows-  .
    G15876969Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Securing exhaust system on transmission jack (similar to illustration)

  2. Fit and tighten screws -1-  on the rear silencer holders -2-  .

    > Tightening torque 23 Nm (17 ftlb.) 

    G15876970Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Rear silencer holders (figure shows V8 Turbo)

  3. Loosen secured decoupling elements -1-  .
    G15876971Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Loosening decoupling elements

  4. Fit exhaust system on transmission support.
    1. 4.1 Fit and tighten screws -4-  on transmission support holders -3-  .

      > Tightening torque 23 Nm (17 ftlb.) 

    2. 4.2 Attach new ball clamps -2-  to the connection between the catalytic converters and front silencer.
      1. 4.2.1 Tighten ball clamps -2-  .

        > Tightening torque 35 Nm (26 ftlb.) 

    G15876972Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Exhaust system on transmission support

  5. Fit holder for centre exhaust system mount -2-  .
    1. 5.1 Fit and tighten screws -1-  .

      > Tightening torque 23 Nm (17 ftlb.) 

      G15876973Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Centre exhaust system mount

  6. For vehicles with sports exhaust system:  Connect vacuum hose -1-  to vacuum unit for exhaust flap -2-  .
    G15876974Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Vacuum hose for exhaust system

  7. Plug in cable plugs -1-  on actuators -2-  .
    G15876975Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Actuator for exhaust flap

  8. For vehicles with rear axle steering:  Fit strut -4-  between the rear silencers.

    > Tightening torque 23 Nm (17 ftlb.) 

    G15876976Courtesy of PORSCHE CARS NORTH AMERICA, INC.

    Exhaust system (figure shows V8 Turbo)

  9. Install tunnel strut -3-  .
    1. 9.1 Fit and tighten screws -1 and 2-  .

      > Tightening torque 50 Nm (37 ftlb.) 

      G15876977Courtesy of PORSCHE CARS NORTH AMERICA, INC.

      Tunnel strut