Installing Front Air-Spring Strut

Information 

Check the following before installing the air line:

• Check that the cutting ring -1-  and Voss threaded joint -2-  are on the air line -3-  (not relevant if the air spring bellows was replaced and the Voss threaded joint that is pre-fitted on the air spring bellows is used).
• Check that the air line is fitted correctly.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Checking air line

Only one marking -1-  on the air line should be visible.

Pull the air line briefly against the insertion direction. If it cannot be pulled out, the air line is fitted correctly.

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Checking that air line is fitted correctly

Information 

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

Air-spring strut holder

• Never carry the spring strut by the holder -1- . If the holder is bent, there is a risk of collision while driving. 

Information 

The help of another person is required for this work.

1. Installation is performed in reverse order. Pay particular attention to the following:
   Fig 1: Body Mounting Saddle Screws Tightening Sequence

   Courtesy of PORSCHE CARS NORTH AMERICA, INC.

   Tightening sequence for mounting saddle to body

   1. 1.1 Tighten nuts securing air-spring strut to mounting saddle.

      > Tightening - torque 30 Nm (22 ftlb.) 

   2. 1.2 Replace screws securing mounting saddle to the body -1 to 4-  .
   3. 1.3 Tighten screws securing mounting saddle to the body in the sequence -1 to 4-  .

      > Initial - tightening 40 Nm (30 ftlb.) 

      > Final tightening + 90° 

   4. 1.4 Tighten air line on air-spring strut.

      > Tightening - torque 3 Nm (2 ftlb.) 

   5. 1.5 Only for removing the right air-spring strut: 

      Tighten nuts on air inlet housing cover.

      > Tightening - torque 3.5 Nm (2.5 ftlb.) 

2. Position DME control unit -1-  and secure with retaining lugs -2-  .

Courtesy of PORSCHE CARS NORTH AMERICA, INC.

DME control unit