Assembling Double Clutch Transmission

WARNING: This page is about a different variant/trim than selected.

Install sensor module.
- WM, 381919 - REMOVING AND INSTALLING SENSOR MODULE
Install wire harness.
- WM, 381819 - REMOVING AND INSTALLING WIRE HARNESS
Install sealing ring for front output shaft.
- WM, 387055 - REPLACING SEALING RING FOR REAR OUTPUT SHAFT
Install ATF pump.
- WM, 385619 - REMOVING AND INSTALLING ATF PUMP
Install control mechanism for transmission.
- WM, 387719 - REMOVING AND INSTALLING CONTROL MECHANISM FOR TRANSMISSION
Install ATF pan.
- WM, 375519 - REMOVING AND INSTALLING ATF PAN
Install drive shaft bearing.
- WM, 380919 - REMOVING AND INSTALLING DRIVE SHAFT BEARING
Install sealing ring for double clutch.
- WM, 386955 - REMOVING AND INSTALLING SEALING RING FOR DOUBLE CLUTCH
Install double clutch.
- WM, 304919 REMOVING AND INSTALLING DOUBLE CLUTCH
Install drive plate.
- WM, 136319 - REMOVING AND INSTALLING DRIVE PLATE (R4)
Install halfshaft flange.
- WM, 392519 REMOVING AND INSTALLING HALFSHAFT FLANGE