Checking Thickness Tolerance

WARNING: This page is about a different variant/trim than selected.

Information

The required technical values must be taken from the
> 4600TW - PSCB TECHNICAL VALUES AND WEAR LIMITS

document.

Measure the brake disc thickness tolerance using a suitable micrometer screw at 8 places within the braking surface.
Result is OK: Install brake disc.
> 465019 - REMOVING AND INSTALLING FRONT BRAKE DISC - SECTION ON "INSTALLING"
Result is not OK: Replace brake disc.
> 465019 - REMOVING AND INSTALLING FRONT BRAKE DISC - SECTION ON "INSTALLING"
Fit wheel.
> 440519 - REMOVING AND INSTALLING WHEEL - SECTION ON "INSTALLING"